ESP-12H-Kit development board
ESP-12H-Kit is a WiFi development board based on ESP-12h module. It comes with a set of warm and cold lamp beads and RGB colorful lamp beads, which can be used to quickly verify the feasibility of intelligent lamp control products. Its core chip is a highly integrated low-power Wi-Fi system on a chip (SoC), which integrates Wi-Fi MAC, Wi-Fi RF and baseband, RF switch, RF Balun, power amplifier, low noise amplifier and so on.
ESP-12H-Kit supports UART/GPIO/ADC/PWM/12c interface, touch sensor, temperature sensor, pulse counter, etc.
ESP-12H-Kit has industry-leading low power consumption and RF performance, and has a variety of unique hardware security mechanisms. It is specially designed for various applications such as the Internet of Things (loT), mobile devices, wearable electronic devices and smart homes.
Product parameter:
Basic information:
Type of product esp-12h-kit
802.11 b/g/n WiFi development board
Package size:
Package size antenna form DIP-30
25.4 * 48.3 * 14.0 (0.2) mm, net weight 7.0 g onboard PCB antenna/reserved IPEX seat
Working frequency:
Typical value 2400-2483.5MHz
Serial port rate:
Support 110 ~ 4608000 bps, default 115200 bps
Pin interface:
Available 10 ports support 18 interfaces.
UART/GPIO/ADC/PWM/12c, etc
Power supply range:
The power supply voltage is 4.75V ~ 5.25V, and 5.0V is recommended.
safety performance:
WEP/WPA-PSK/WPA2-PSK
working environment:
Operating temperature-40℃ 85℃
Storage environment-40℃ ~ 125℃, < 90% RH
Module certification:
RoHS/REACH
power consumption:
Modem-Sleep 19mA
Light-Sleep 450HA
Deep-Sleep 235HA
Power Off lpA
output rating:
Lln mode HT40, PA 13±2 dBm
LLn mode HT20, PA 13±2 dBm
11g mode, PA 15±2 dBm
Lib mode, PA 18±2dBm
receiving sensitivity:
CCK, 1 Mbps W-97 dBm
CCK, 11 Mbps W- 88 dBm
6Mbps(l/2BPSK) W- 92 dBm
54 Mbps (3/4 64-QAM) W-75 dBm
HT20 (MCS7) W-72 dBm
HT40 (MCS7) W- 69 dBm
Pin definition:
1 IO38 GPIO38/FSPIWP
2 IO37 GPIO37/FSPIQ
3 IO0 GPIOO
4 IO34 GPIO34/FSPICS0
5 IO33 GPIO33/FSPIHD
6 3V3 POWER
7 GND GROUND
8 IO11 GPI011/TOUCH11 /ADC2_CH0/FSPID/FSPIIO5
9 IO12 GPI012/T0UCH12/ADC2_CH1 /FSPICLK/FSPII06
10 NC -
11 IO10 GPI010/TOUCH10/ADC1_CH9/FSPICSO/FSPII04
12 RX U0RXD/GPIO44/CLK_OUT1
13 TX U0TXD/GPIO43/CLK_OUT2
14 GND GROUND
15 3V3 POWER 3.3V
16 NC -
17 IO1 GPI01 /TOUCHI/ADC1_CH0
18 IO2 GPIO2/TOUCH2/ADC1_CH1
19 IO5 GPIO5/TOUCH5/ADC1_CH4
20 IO7 GPIO7/TOUCH7/ADC1_CH6
21 IO8 GPIO8/TOUCH8/ADC1_CH7
22 IO9 GPIO9/TOUCH9/ADC1_CH8/FSPIHD
23 IO20 GPI020/U1 CTS/ADC2_CH9/CLK_OUT1 /USB_D+
24 IO19 GPI019/U1 RTS/ADC2_CH8/CLK_OUT2/USB_D-
25 GND GROUND
26 3V3 POWER 3.3V
27 EN Power enable pin
28 1021 GPI021
29 GND GROUND
30 5V POWER 5V
- Comments(0)
You might like
ESP-12H-Kit development board
Out of stock
