Top Solder Mask
Top Paste Mask
Top Overlay
Top Copper Layer
Mill Layer
Bottom Solder Mask
Bottom Paste Mask
Bottom Overlay
Bottom Copper Layer
NC Drill
Bottom
Top
Shield_DMM
This miliohm meter can be very useful in some cases - it can be used during debugging of some electronics devices which have short connections inside, to locate defected capacitors, resistors, chips..etc.By scanning the area around the short it cab be easily located the burned out device measuring the resistance of the conductive PCB tracks and finding the place with minimum resistance. If you are interested more about this process - you can find a lot of videos about.
All neededed information can be found under this link: http://www.instructables.com/id/Miliohm-meter-Arduino-Shield-Addendum/
Shield_DMM
*PCBWay community is a sharing platform. We are not responsible for any design issues and parameter issues (board thickness, surface finish, etc.) you choose.
- Comments(0)
- Likes(0)
More by Mi6026en Pen
-
-
-
-
Enter the title_ of your projectEnter the title_ of your projectEnter the title_ of your projectEnter the title_ of your projectEnter the title_
12 0 0 -
-
