I was taking things apart since I was old enough to turn a screwdriver.

Recommended
Shared Projects Questions Sponsorships Feedback Blog Like
All robots have brains, even the insect size ground rovers do a remarkable job of negotiating rough terrain with nothing more than a few switch sensors. These small robots are fun to construct and dem...
This application proposal provides a circuit design for a generic base board for driving various IGBT power modules up to a maximum blocking voltage of 1200V. The design depends on the specific requir...
This post continues from “How to Design the Perfect PCB – Part 1.” In part one we covered how to finish the pre-layout work like setting goals, visualizing your design, and selecting parts. In this po...
As with many aspects of IC design and verification, standards give engineers the ability to describe design intent, move design data through the design flow, and document the final design.
Simple Sound Processor presented here is an ultra-simple circuit module suitable for almost all basic electronics and microcontroller projects. For example, this module can be used as a front-end in a...
This is a guest post from Thomas Amely on how to make your own CNC milled PCBs. A short author bio is included at the bottom of this post. Have fun making and enjoy the post!
This post is the first in a two part series about designing the perfect printed circuit board (PCB). This part focuses on the pre-layout details that may be more important than you realize. The second...