Particle Boron LTE CAT-M1
Description：
The Boron LTE is a powerful LTE CAT-M1 enabled development board that can act as a standalone cellular endpoint. It is based on the Nordic nRF52840 and has built-in battery charging circuitry so it’s easy to connect a Li-Po and deploy your local network in minutes.
The Boron LTE CAT-M1 (NorAm) or BRN402 features the same form factor as the rest of the Particle’s Boron series modules and comes with a full set of regulatory and industry certifications to dramatically accelerate time to market. The BRN402 is certified only for use with the Taoglas Cellular Flex Antenna 2G/3G/LTE 5dBi.
Please note: Use of a different antenna with the above module may violate regulatory certifications and require additional certification. Refer to our antenna documentation for additional information regarding regulatory compliance and certification of Particle modules.
Contents:
- Boron LTE development board (On-board SIM, no card necessary)
- Cellular flex antenna
Specs:
- u-blox SARA R410 LTE modem
-LTE CAT M1 module with global hardware support (MVNO support for US only)
-3GPP Release 13 LTE Cat M1
- Nordic Semiconductor nRF52840 SoC
-ARM Cortex-M4F 32-bit processor @ 64MHz
-1MB flash, 256KB RAM
-IEEE 802.15.4-2006: 250 Kbps
-Bluetooth 5: 2 Mbps, 1 Mbps, 500 Kbps, 125 Kbps
-Supports DSP instructions, HW accelerated Floating Point Unit (FPU) calculations
-ARM TrustZone CryptoCell-310 Cryptographic and security module
-Up to +8 dBm TX power (down to -20 dBm in 4 dB steps)
-NFC-A tag
- On-board additional 4MB SPI flash
- 20 mixed signal GPIO (6 x Analog, 8 x PWM), UART, I2C, SPI
- Micro USB 2.0 full speed (12 Mbps)
- Integrated Li-Po charging and battery connector
- JTAG (SWD) Connector
- RGB status LED
- Reset and Mode buttons
- Dual SIM support: Nano 4FF (unpopulated) and MFF2
- U.FL connector for external antenna
- Meets the Feather specification in dimensions and pinout
- FCC and PTCRB certified
- RoHS compliant (lead-free)
- Comments(0)
You might like
Particle Boron LTE CAT-M1
Out of stock
