This circuit exactly mimics the original rotating brush on his commutator used on the controller part G. using 16 channels cuts was down on heat as well as on time for each PNP transistor. in a make b...
Fire Flow is a an Arduino core based controller (ATMega2560) for convectional oven. It can be used for different jobs but his main advantage is that it can convert a simple oven into reflow oven. It...
This project is for some old machines that needed the old case 3 MHz PTH 5V oscillator with new, cheap and little smd components.
4.5x4.5cm PCB
Each one of this board have 8 outputs and 8 inputs. The input is protected with a zener to limit the voltage and protect the microcontroller. The output have a transistor and give 500mA at 12Vcc to po...
The project is in the developement phase, but it sholuld be okay after carefully modelling and designing. For more informations please contact me...
Use PIC for management and RS485 for communication
This is USB Dongle key with wifi, SDRAM and Flash memory
Board Dimension : 20 x 27 mm This device is going to be mounted on toothbrush. It will be helpful to children with encouraging toothbrushing. It communicates with mobile app(a kind of game).
Part of a larger system, this provides the connectivity to a Trimble BD970 GPS module.
RS485 and Wiegand Card Reader with User Friendly Software
It is an IR temperature sensor. arduino compatible processor. USB interface, sends the temperature measurement to the PC. measures 2.5X5.0cm
.
New project of ilumination for salt water reef aquarium
A very simple project that kids enjoy doing that allows them to learn to solder and learn just a little bit of how circuits work. A connector, switch, super cap, LED and a few current limiting resist...
These are two instruments I have designed from my workshop of digital craftery (Artesania Digital) Batebit.cc