4-Layer, 1.6mm PCB Very professional manufactured PCB.
Contactor Board with Can interface card to On/off Different Loads for Constant current DC load. The DC load to be controlled using Can Bus to change the loads.
Components for Flight Simulator Interface
THIS IS A BOARD WERE WE HAVE DEVELOPET UN VHF UHF AMPLIFIER
El proyecto es un detector magnetico que se puede utilizar en multiples trabajos. Por ejemplo deteccion de abrir o cerar de puertas, contador de bobinadoras, motores sin escobillas, etc.
8/8 mils trace/spacing with 40 mils text, TSSOP packages (0.5mm pitch), 45 mils text with 6 mils line widths. My biggest concerns where accuracy and plating quality : I've dealt with another manufa...
These business cards feature a small 3-chip prototype area!
led reset board for raspberry pi
conversion lights board
This is a technological discussion on designing a fabrication friendly PCB
aplication for system
Bricks of Arduino
The project is to provide an improved output section replacement of a commercial digital crossover (audio DSP). The heart of the system is a buffered differential amplifier followed by a gain stage c...
I'm building a clock out of relays (DPDT)
Converts the MF and HF Bands (1MHz to 22MHz) to the VHF Band (30MHz to 52MHz), intended for use in receivers. The HF Converter is a very small board with a backside female RF connector.
this is a PCB designed for characterizing opamps