This is a mechatronoics project completed at the university of Newcastle by 3rd and 4th students independently. components used are: Atmel ATMEGA32A micro-controller, GY-521 6 DOF MPU-6050 Module 3Ax...
Using a Fairchild SPM module and a Delfino Microcontroller we are designing a three phase inverter.
Controller board for a powerful LED strobe light. Used as a tail strobe on home built aircraft. This one has switchable modes and two circuit operation. www.flyleds.com
These boards used relays to turn on/off high current outputs
Replaces the Famicom power/rf board with a clean dc board and RCA outputs
I needed a way to control 4 motors with only 1 controller, this little board done the trick!
A PICAXE microprocessor is connected to the radio buttons and when required turns on the Bluetooth module to provide a connection to a phone or tablet and allow music to be played. The Bluetooth modu...
The project uses a 32bit Microchip MCU to control the automatic testing process. The PCB assembly to be tested is placed on 4 guides and above a bed of pogo pins. A lever presses and holds down the ...
Using a fairchild SPM and Delfino Microcontroller, we are designing and three phase inverter.
Wing mounted boards that have red/green position lights and bright LED strobes
Controller board for a powerful LED strobe light. Used as a tail strobe on home built aircraft. www.flyleds.com
-
Designed in Altium, 1.6mm thick, 2 layer, HASL, 36 x 35mm.
PCB is for the analog front end of the scope, which interfaces with a Tiva C development board, which provides the ethernet PC connection. Channel A also affords band pass sampling from 650-750kHz. Fi...
I am very happy with the quality of the PCB, the holes aligned perfectly with the bolts of the chassis.
A small 4% programmable keyboard running on an Attiny15 based off of a project by Benchoff "Unhappy Hacking Keyboard"
1 ... 31 32 33 34 35 36 37 38 39 40 41