This project aims at the creation of a modular caravan status display and automation system. The design consists of two PCBs at the moment One PCB tracks the battery status using a commercial availabl...
USB-Host-Controller with FTDI Vinculum Chip and a GIDE-Board (c)Kingstener for old robotron-Computer.
The MicroFTX is a small FTDI Breakout. It uses the new FT230X chip which has a bigger buffer for reading and writing and is a bit more stable than older FTDI chips. It's small size makes it perfect t...
- Powered via PoE - 2x Front USB 2.0 - HDMI - serial console via USB (integrated serial USB converter) - 18x USB 2.0 ports at the backside for interface cards at the VG-connector. - additiona...
4x servo decoder module for Selectrix systems
This Board is for a Wordclock (Qlocktwo). It has a Atmega1284P and a DS1307 Clock IC onboard, Pin's for a LDR and a DCF Receiver. The Bootloader is from the Sanguino package.
SWR bridge with DDS signal generator. DDS and measurement is managed by mikrocontroller( Arduino).
This is a digital synthesizer with 6 voices and a simple control surface based on a LCD with some pots and buttons.
Will put two of these side by side and add a control with nRF24L01 to set time alarms welcome messages everything
USB-Host-Controller with FTDI Vinculum Chip and a GIDE-Board for old robotron-Computer.
Aquarium lamp with 30 RGB and 30 5730 10000K LEDs on a aluminum board.
I needed a small display to show some infos. The shematics were made in EagleCad. PCBWay made them fast and in perfect quality :).. It's my first PCB, it's not that nicely designed, but it works fin...
Data transmission via USB and 886MHz.
Controlling the Door-Lock, unauthorized opening of doors and preventing the car to start by remote.
2 layer, 106x36mm, without silkmask
to control havac and chiller with an opencontroller system.
1 ... 15 16 17 18 19 20 21 22 23 24 25