Product Description
AZEnvy - Environment sensors development board
The AZEnvy or AZ-Environmental is an ESP12F based developer board, especially for the easy entry into the world of IoT.
The board offers a wide range of possible uses for makers, hobbyists and engineers, such as use as a weather station, gas meter, mold preventer, garden shed monitoring and much more ...
It offers the following options in use:
- measurement of temperature (° C) and humidity (%)
- measurement of ambient gases in ppm
- setup and / or connection to a network
- variable voltage supply from 3V to 11V via Micro USB (cable not included)
- programming via FTDI chip (not included)
The microprocessor – ESP12F:
- smallest available 802.11b/g/n Wi-Fi SOC module
- very low power 32-bit CPU with up to 160MHz clock speed
- built-in 10bit high precision ADC
- deep sleep current as low as 0.02mA
- UART baud rate up to 4Mbps
- possibility to include AT commands
- programmable via FTDI interface and push buttons on the surface
The included Gas Sensor – MQ-2:
- sensors conductivity is much higher when the gas concentration rises
- can be used as:
* Domestic gas leakage detector
* Industrial Combustible gas detector
* Portable gas detector
- Good sensitivity to combustible gas in wide range /high sensitivity to LPG, Propane and Hydrogen / long life and low cost
The temperature and humidity sensor – HDC1080:
- relative humidity accuracy ±2%
- temperature accuracy ±0.2°C
- 14 Bit measurement resolution
- 100nA sleep mode current
- I2C Interface
Programming concerns
- Arduino IDE
- Library → HDC1080
- Gas Sensor is connected to Pin ADC (analogue output)
- Pinout Diagram ESP12F
(The case is not included.)
Possible projects:
- weather Station with data transfer to Google Firebase
- gas meter
- unit to measure temperature and relative humidity → prevent mold
- garden shed monitor
- Comments(11)
Upload photo
You can only upload 5 files in total. Each file cannot exceed 2MB. Supports JPG, JPEG, GIF, PNG, BMP
0 / 10000
